Q1 How many trunks can be found?
3
Q2 Which EtherChannel negotiation protocol
is in use here?
The EtherChannel
negotiation protocol in use is PAgP.
Q3 How many VLANs
can be supported locally on the 2960 switch?
This switch
and Cisco IOS Software version can support 255 VLANs.
Q4 How many existing
VLANs are in the VTP domain?
There should
be nine VLANs: the five built-in ones, plus the four new VLANs that you just
created.
Q5 Success? Are
these results expected at this point? Why?
Cannot be
ping.
It is expected
that the pings will fail because no SVIs have been created on DLS1 and DLS2,
except for VLAN 1. Therefore, there is no default gateway for the hosts.
Q6 Which VLANs are
active in DLS1 and DLS2 respectively.
DLS1 – 1, 10,
20
DLS2 – 30, 40
Q7 What is the
default hello time for each VLAN? What is the default hold time?
The default hello
time is 3 seconds. The default hold time is 10 seconds.
Q8 How is the active
HSRP router selected?
The router
with the highest priority is selected as the active HSRP router. If more
routers share the highest priority, the HSRP router with the highest IP address
on the segment becomes the active router.
Q9 Success?
Yes
Q10 What is the
output on the console of DLS1?
1w3d:
%HSRP-6-STATECHANGE: Vlan30 Grp 1 state Standby -> Active
1w3d:
%HSRP-6-STATECHANGE: Vlan40 Grp 1 state Standby -> Active
沒有留言:
張貼留言